Mechanical Design & CAD
SolidWorks assemblies, mechanisms, constrained packaging and motion-oriented design.
Service
Robotics & Automation
Prototypes that move — sensing, control and navigation integrated into one dependable build, with the documentation to run it.
Robotics work fails at integration far more often than at any single component. We take responsibility for the whole build — mechanical, electronics, firmware and control — so there is no gap between vendors where the problem can hide.
Every engagement ends with a working demonstration, the source, and the wiring and safety documentation needed to operate it without us.
What the work covers
- Arduino, STM32 and PLC development
- ROS and ROS2 packages with Gazebo or RViz simulation
- Motion planning, teleoperation and safe actuation
- Sensor integration — LiDAR, depth cameras, IMU, encoders
- Motor drivers, power and enclosure integration
- Bench testing with demo footage and recorded metrics
Frequently asked
Which platforms do you build on?
Arduino, STM32 and PLCs for embedded control, and ROS or ROS2 on Raspberry Pi or Jetson where a full robotics stack is needed.
Can you integrate sensors?
Yes — LiDAR, depth cameras such as RealSense, IMUs and encoders, including the calibration and fusion work that makes them usable.
Do you deliver simulation or hardware?
Either. Simulation first is usually cheaper for proving motion planning; on-hardware bring-up follows once the approach is settled.
Proof
Tell us what you're building.
We reply within 24 hours with a clear scope, fixed deliverables and a realistic timeline.